Exchange Server Hub transport rule sayesinde spamcılara döndürebileceğiniz mesajların listesi aşağıdaki gibidir
Collected Status Codes
First Digit
4.X.X Persistent Transient Failure
5.X.X Permanent Failure
Second and Third Digits
X.1.1 Bad destination mailbox address
X.1.2 Bad destination system address
X.1.3 Bad destination mailbox address syntax
X.1.4 Destination mailbox address ambiguous
X.1.5 Destination mailbox address valid
X.1.6 Mailbox has moved
X.1.7 Bad sender’s mailbox address syntax
X.1.8 Bad sender’s system address
X.2.0 Other or undefined mailbox status
X.2.1 Mailbox disabled, not accepting messages
X.2.2 Mailbox full
X.2.3 Message length exceeds administrative limit
X.2.4 Mailing list expansion problem
X.3.0 Other or undefined mail system status
X.3.1 Mail system full
X.3.2 System not accepting network messages
X.3.3 System not capable of selected features
X.3.4 Message too big for system
X.4.0 Other or undefined network or routing status
X.4.1 No answer from host
X.4.2 Bad connection
X.4.3 Routing server failure
X.4.4 Unable to route
X.4.5 Network congestion
X.4.6 Routing loop detected
X.4.7 Delivery time expired
X.5.0 Other or undefined protocol status
X.5.1 Invalid command
X.5.2 Syntax error
X.5.3 Too many recipients
X.5.4 Invalid command arguments
X.5.5 Wrong protocol version
X.6.0 Other or undefined media error
X.6.1 Media not supported
X.6.2 Conversion required and prohibited
X.6.3 Conversion required but not supported
X.6.4 Conversion with loss performed
X.6.5 Conversion failed
X.7.0 Other or undefined security status
X.7.1 Delivery not authorized, message refused
X.7.2 Mailing list expansion prohibited
X.7.3 Security conversion required but not possible
X.7.4 Security features not supported
X.7.5 Cryptographic failure
X.7.6 Cryptographic algorithm not supported
X.7.7 Message integrity failure
The following is from RFC 1893: This document defines a new set of status codes to report mail system conditions. These status codes are intended to be used for media and language independent status reporting. They are not intended for system specific diagnostics.
The syntax of the new status codes is defined as:
class = “2”/”4″/”5″
subject = 1*3digit
detail = 1*3digit